How to fit Half Solid Raised Shutters
How to fit Half Solid Raised Shutters
Fit Half Solid Raised Shutters by securing the frame, aligning the panels, and fastening the hinges. Ensure proper positioning for a seamless finish.
Tools you will need:
Fitting Guides
Frames will be labelled Left, Right, Top and Bottom. Lay the content on the floor.
Step1
Connect the frames
L Frames
Connect frames using the Hoffmann key provided when on the floor.
Slide each corner together.
Z Frames
Unlike the L Frames, the bottom of the Z frame is secured with screws with pre drilled holes.
T Post
Place the frame on the floor with the panels attached, then use a packer wedge to ensure a uniform gap at the top and bottom between the shutter side and the T-post. Once aligned, secure the T-posts by screwing them into the top and bottom.
Step2
Position the frame within recess
Step3
Pre-drill desired fixing points
Step4
Mount the panels
Step5
Line up panels
Step6
Re pack the frame and make holes
Once the panels are aligned at the top, follow these steps:
A – Repack the frame.
B – Open the panels.
C – Partially insert the screws to mark the wall, then remove them.”
Step7
Screw the rest of fixing points
Step8
Tight screws
Step9
Mount the panels back
Step10
Place screw covers to the screw holes
Step11
Seal gaps
Important
